Epson LQ-570e - Operation; Control Panel; Switches

EPSON LQ-570e/LQ-580 Revision C
Product Description
O
peration
3
1
1.5 Operation
1.5.1 Control Panel
6 switches and 8 LEDs are on the panel as shown below.
Figure 1-8. Control Panel
1.5.1.1 Switches
o Operation in normal mode
In normal mode, pressing panel switches executes following function;
Draft
Rom an
Sans serif
Font
Reset
T ear O ff/B in
Tear Off
Bin 1
Bin 2
Card
Pause
Micro Adjust
3sec.
Paper O ut
LF/FF
Load/Eject
: L E D O n , : L E D B lin k s ,
: L E D O ff
C ourier
Prestige
Script
Others
C ondensed
Table 1-28. Operation in Normal Mode
Switch Function
Pause
-Alternates printing and non-printing status.
-Enables Micro Adjustment function, holding it down for 3 seconds.
-If pressed again in the above condition, Micro Adjustment function
is disabled.
Load/Eject
Micro Adjust ↑
-When no cut sheet/ CSF, load paper from CSF.
-When there is cut sheet/ CSF, eject paper.
-When no continuous paper, load continuous paper.
-When there is continuous paper, eject continuous paper to the
tractor waiting position.
-When Micro Adjust is enabled, execute micro feed backward.
(0.14mm (1/180 inch)) *1: See Figure 1-9, "Micro Feed".
-After paper feed; at TOF position, TOP adjustment is executed; at
TEAR OFF position, TEAR OFF position adjustment is executed; at
other positions, micro feed is executed.
LF/FF
Micro Adjust ↓
-When no cut sheet/ CSF, load paper from CSF.
-When there is cut sheet/ CSF; if pressed short, start a new line; if
pressed for seconds, eject paper; if roll paper, start a new line.
-When no continuous paper, load continuous paper.
-When there is continuous paper; if pressed short, start a new line; if
pressed for seconds, start a new page.
-When Micro Adjust is enabled, execute micro feed forward.
(0.14mm (1/180 inch)) *2: See Figure 1-9, "Micro Feed".
-After paper feed; at TOF position, TOP adjustment is executed; at
TEAR OFF position, TEAR OFF position adjustment is executed; at
other positions, micro feed is executed.
Tear Off/ Bin
-If cut sheet is selected, select CSF bin. (Including CARD)
-If continuous paper is not at TEAR OFF position, carry continuous
paper to the next page Tear-off position.
-If continuous paper is at TEAR OFF position, carry continuous
paper to the next page TOF position.
-If no continuous paper, TEAR OFF SW is invalid.