Epson LQ-570e - PG (Platen Gap) Detector Removal; Release Detector Removal

EPSON LQ-570e/LQ-580 Revision C
Disassembly and Assembly Disassembly and Assembly
8
6
4.2.9.4 PG (Platen Gap) Detector Removal
1. Remove the printer mechanism. (See 4.2.7 "Printer Mechanism Removal".)
2. Remove 2 clips of PG detector attached to the left frame of the printer mechanism and
remove the detector.
Figure 4-19. PG Detector Removal
4.2.9.5 Release Detector Removal
1. Remove the printer mechanism. (See 4.2.7 "Printer Mechanism Removal".)
2. Remove 2 clips of Release detector attached to the right frame of the printer
mechanism and remove the detector.
Figure 4-20. Release Detector Removal
PG Detector
Release Detector
(The detector is on the
back side of the frame.)