Epson LQ-570e - Adjusting the Top-of-Form Position

EPSON LQ-570e/LQ-580 Revision C
Disassembly and Assembly Disassembly and Assembly
7
4
4.2.1 Pre-disassembly Procedures
Before starting disassembly procedures, the following parts must be removed. (see the
figure below.)
Figure 4-2. Parts Name
Remove the top cover and paper guide assembly. Removal of the other parts is explained in
detail below.
4.2.1.1 Front Cover Assembly Removal
FRONT COVER ASSEMBLY
1. Open the front cover assembly by releasing 2 top hooks locking the upper housing.
2. Release 2 hooks on bottom side of the front cover assembly from the location shafts of
lower housing from the front bottom.
NOTE: 2 hooks and 2 location shafts must be free from any damage, -crack, bent
nor white mark.
KNOB
1. Pull out the knob from the shaft of the platen.
Paper Guide Assembly
Top Cover
Front Cover
Tranctor Assembly
Knob
To push the front cover assembly, do not push vertically or
horizontally. Must push about 45 degree from front.
Matching the “D”-shaped cut.