Epson LQ-570e - Rear Paper Guide Assembly Removal

EPSON LQ-570e/LQ-580 Revision C
Disassembly and Assembly Disassembly and Assembly
9
0
4.2.9.9 Rear Paper Guide Assembly Removal
1. Remove the printer mechanism. (See 4.2.7 "Printer Mechanism Removal".)
2. Remove the upper head cable and the lower head cable from the printhead and remove
the printhead. (See 4.2.1 "Pre-disassembly Procedures".)
3. Remove the platen cover and remove platen. (See 4.2.8 "Platen Removal".)
4. Remove the hexagon nut, release lever, washer and the bushing parallel adjust.
Remove the adjust parallel bushing. (See 4.2.9.8 "Carriage Assembly Removal".)
5. Remove the harness of PG detector. (See 4.2.9.4 "PG (Platen Gap) Detector Removal")
6. Remove the harness of HP detector from the left frame. (See 4.2.3 "HP (Home
Position) Detector Removal")
7. Remove 4 CBS (3x8, F/ZN) screws securing the left frame to the printer mechanism,
and remove the left frame.
8. Remove the upper head cable and the lower head cable from the printhead. (See 4.2.1
"Pre-disassembly Procedures".)
9. Remove 2 CBS (3x8, F/ZN) screws securing the rear frame to the right frame and
remove the rear frame with rear paper guide assembly.
10. Push the clip on the bottom of the rear paper guide assembly, and slide out the rear
paper guide assembly from the frame rear.
(See Figure 4-27. "Rear Paper Guide Assembly Removal")
Figure 4-27. Rear Paper Guide Assembly Removal
ADJUSTM ENT
REQUIRED
After removing the rear paper guide assembly, perform the parallel
adjustment and PG adjustment.
Clip