Epson LQ-570e - Using the Printer Driver With Windows 95 and 98

EPSON LQ-570e/LQ-580 Revision C
Adjustment Adjustment and Resetting the Printer
9
7
5.2.3 Factory Setting
The factory settings of the printer for each destination are installed in the EEPROM on the
main board. Therefore, If you have replaced the main board, you must re-install them again
by the adjustment program. This section describes how to install the factory settings:
1. Connect the printer and the host DOS/V computer with a parallel interface cable.
2. Set the 10 inch width continuous paper to the printer.
3. Run the adjustment program in the host computer.
Program Name: Q80A10V
* Run “Autoexec.bat” file from attached 3.5 inch program FD.
4. Operating System selet menu appears. Type “G” to run GWbasic.
5. Printer Name inputting menu appears. Input “LQ-570e or LQ-580”.
6. The printhead wire select menu appears. Move the cursor using “
↑ ” or “ ↓ ” key to
select “24 pin” from the list and press “
Enter” key.
7. Then the market setting menu appears. Referring to the market list table, move the
cursor using “
↑ ” or “ ↓ ” key to select your market from the list and press “ Enter ” key.
To change the choice to the other market after selection, you may press “
ESC ” key
only. The market setting menu appears again. An example (for EUR) is shown below:
Table 5-3. Market List
Destination Code Destination Code
EAL, ESP, EHK,
EHK(PHIL)
USASTD EDG (NLSP), EUL (NLSP),
EIS (NLSP)
NLSP
EURO, EDG, EUL,
EUL (230V, 240V), EFS,
EIS, EIB
EURSTD EUL (120V) DEFSTD
EAI, EAI (Latin) USASTD2 EKL KOREAN
EMO RUSSIAN