Option
5-3
Installing the Film Adapter
Follow the steps below to install the Film Adapter on the scanner.
1. Make sure the scanner is turned off.
2. Remove the document cover from the scanner by opening it
and pulling it straight up.(See “Removing the Cover for Thick
or Large Documents” on page 6-5)
3. Place the Film Adapter on the document table so that the
hinges face the rear of the scanner and it fits on the table.
35mm strip film 35mm strip film (to be scanned
from EPSON Photo Print)
120/220 (6cm
×
9cm film) 4
×
5 inch film
To Next Page
Loading...
