PR2 mode
State of panel lights Beep pattern Problem
Solution
N Power
F Ready
— There is no paper loaded in the slot.
Load a paper into the front slot.
— Paper is not loaded correctly.
Remove the paper and reload it correctly. See “Loading Passbooks”
on page 17, or “Loading Single Sheets” on page 18.
— Paper is not fully ejected.
See “Clearing a Paper Jam” on page 82 for instruction on ejecting
paper.
— Paper is jammed in the printer.
To clear the paper jam, see “Clearing a Paper Jam” on page 82.
N Power
N Offline
— The printer cover is open.
Stop the operation and close the printer cover.
N Power
F Offline
— The print head is overheated.
Wait for a few minutes; the printer resumes printing automatically
once the print head cools.
N Power
F Ready
F F1/Eject
F Offline
F F2
An unknown printer error has occurred.
Turn off the printer and leave it off for several minutes; then turn on
the printer again. If the error recurs, contact your dealer.
N = on, F = flashing
= long series of beeps (five beeps)
PLQ-30/PLQ-30M User’s Guide
Troubleshooting 73
To Next Page
Loading...
