Epson PP 803 - Page 219

Appendix D IBM ProPrinter Quick Refernce
D-5
Table 3 (Cont.): Vertical Form Handling
Escape Sequence Mnemonic Function
ESC [ ; ; P3 s Paper Exit:
Native Command P3 = 0 : reserved
P3 = 1 or 2 : Paper Exit Front (manual)
P3 = 3 : Batch output (rear), default
ESC [ ; ; ; P4 s Cut Mode On/Off: )
3
Native Command P4 = 0 : Cut Mode Off
P4 = 1 : Cut Mode On
P4 = 2 : Cut on actual position
(cutting edge is approximate 4 mm above the base of the actual line)
) only active if
CUT DEVICE = YES
3