219
Setting Options Description
A/V Settings A/V Output Select Always On to set a fixed
IP address and move the lens to
the home position when the
projector is in standby mode (the
Standby Mode setting must be
set to Communication On)
Standby Mode Communication On
Communication Off
Enable this setting to allow the
following operations to occur
when the projector is in standby
mode:
• Monitor and control the
projector over a network
• Output video to an external
device (A/V Output must be
set to Always On )
• Communication from the
HDBaseT port (Control
Communications must be set
to On in the HDBaseT
settings)
HDBaseT Control Communications
Extron XTP
Selects the communication
settings for connections to an
HDBaseT transmitter or switcher
Control Communications:
enables or disables
communication from the Ethernet
and serial ports on the
transmitter; turning on this setting
disables the projector's LAN, RS-
232C, and Remote ports (Extron
XTP must be turned off to use
this setting)
Extron XTP: set to On when you
connect an Extron XTP
transmitter or switcher to the
HDBaseT port
To Next Page
Loading...
