Epson SC-F100 Series User Manual

E-11
Message:
Setup is incomplete. Conrm default gateway setup. Connection using the EpsonNet Setup is available. Contact
your network administrator for assistance.
Solutions:
Check the following.
❏ e default gateway address is correct if you set the printer's TCP/IP Setup setting to Manual.
❏ e device that is set as the default gateway is turned on.
Set the correct default gateway address. You can check the default gateway address from the Network Status part
on the network connection report.
Related Information
& “Setting Items for Advanced Network Settings” on page 27
& “Printing a Network Status Sheet” on page 36
E-12
Message:
Conrm the following -Entered security key/password is correct -Index of the security key/password is set to the
rst
number -IP address, subnet mask, or default gateway setup is correct Contact your network administrator for
assistance.
Solutions:
Check the following.
❏ Other devices on the network are turned on.
❏ e network addresses (IP address, subnet mask, and default gateway) are correct if you are entering them
manually.
❏ e network addresses for other devices (subnet mask and default gateway) are the same.
❏ e IP address does not conict with other devices.
If still does not connect your printer and network devices aer conrming the above, try the following.
❏ Tur n
o
the access point. Wait for about 10 seconds, and then turn it on.
User's Guide
Network Settings
34

Epson SC-F100 Series Specifications

General

Brand	Epson
Model	SC-F100 Series
Category	Printer
Language	English