6.
Tap the Enter Password
eld,
and then enter the password.
Note:
❏ e password is case-sensitive.
❏ If you do not know the password, check if the information is written on the label of the wireless router. On the label,
the password may be written "Network Key", "Wireless Password", and so on. If you are using the wireless router
with its default settings, use the password written on the label.
7.
When you have setup nished, tap Start Setup.
8.
Tap Close.
e screen automatically closes aer a specic length of time if you do not tap Close.
Note:
If you fail to connect, load A4 size plain paper, and then tap Print Check Report to print a connection report.
9.
Tap Close on the network connection settings screen.
Related Information
& “Entering Characters” on page 24
& “Checking the Network Connection Status” on page 173
Making Wi-Fi Settings by Push Button Setup (WPS)
You can automatically set up a Wi-Fi network by pressing a button on the wireless router. If the following
conditions are met, you can set up by using this method.
❏ e wireless router is compatible with WPS (Wi-Fi Protected Setup).
❏ e current Wi-Fi connection was established by pressing a button on the wireless router.
1.
Tap
on the home screen.
2.
Tap Wi-Fi (Recommended).
If the printer has been already connected by Ethernet, tapRouter.
3.
Tap Start Setup.
If the network connection is already set up, the connection details are displayed. Tap Change Settings to
change the settings.
If the printer has been already connected by Ethernet, tap Change to Wi-Fi connection., and then tap Ye s
aer conrming the message.
4.
Tap Push Button Setup(WPS).
Adding or Replacing the Computer or Devices
>
Re-setting the Network Connection
>
Making Wi-
…
162
To Next Page
Loading...
Need help?
General
