Tips on using continuous paper
Follow the tips below when printing on continuous paper.
❑
If the printer runs out of paper during a print job, load
paper in the tractor feeder and press the
Pause
button to
continue printing.
❑
You can use the micro-adjust feature to adjust the loading
position or tear-off position. See “Adjusting the loading
position” or “Adjusting the tear-off position” below. The
settings you make remain in effect until you change them
again, even if you turn off the printer.
c
Caution:
Do not use the knob on the left side of the printer to adjust
the loading position. Otherwise, you may damage the
printer or cause it to lose the top-of-form position.
❑
If paper slips out of the sprocket pins, re-insert the paper
into the pins before feeding the paper backwards.
Adjusting the loading position
You can adjust the loading position of continuous paper using
the micro-adjust feature. Before adjusting the loading position,
load continuous paper to the top-of-form position using the
Load/Eject
button. See page 5-8 for details.
Adjusting the tear-off position
When you press the
Load/Eject
button after you have finished
printing a page, you may find that the perforation is not
aligned with the tear-off edge. You can use the micro-adjust
feature to adjust paper to the tear-off edge. When you resume
printing, the printer feeds paper back to the loading position.
5
R
Loire-p Ref. Guide
Rev.c
A5 size Chapter 5
02-24-97 DR, pass 0
Paper Handling
5-15
To Next Page
Loading...
