Connecting the Printer to Your Macintosh
The method you use to connect the printer to your Macintosh
depends on whether you want to connect directly to the printer
using the printer’s built-in serial interface, or you want to
connect the printer to a network using an optional interface
card (see the next page).
Using the built-in serial interface
To use the printer’s built-in serial interface, you will need
an Apple System Peripheral-8 cable. Read the following steps
to connect the printer to your Macintosh.
1. Make sure both your printer and Macintosh are turned off.
2. Connect one end of the interface cable to the serial connector
on the back of the printer.
a-602
L
Loire-P Ref. Guide
Rev.c
A5 size Chapter 2
02-24-97 DR, pass 0
2-22
Getting Started
To Next Page
Loading...
