Initialization
The printer can be initialized (returned to a fixed set of conditions) in
these ways:
Hardware initialization ∗ The printer is turned on.
Control panel initialization ∗ Hold down the
Pause
button for five
seconds.
∗ The printer receives an
INIT signal from
the parallel interface: pin 31 goes LOW.
Software initialization ∗ Software sends the ESC @ (initialize the
printer) command.
Each kind of initialization has slightly different effects. All three methods
reset the font according to the default settings selected using the control
panel. However, the control panel initialization does not initialize the
printer mechanism, ESC @ does not initialize the printer mechanism, clear
the input data buffer, or clear the user-defined character set.
Note:
When the printer initializes, all lights on the control panel come on for a moment
and they return to their previous status.
L
Loire-p Ref. Guide
Rev.c
A5 size Appendix D
02-24-97 DR, pass 0
D-18
Specifications
To Next Page
Loading...
