Setting Options
Skip over perforation Off, On
Auto tear off Off, On
Banner mode Off, On
Parallel I/F transfer
rate
Fast, Normal
* IBM mode only
For details, see “About the default settings” below. To change a
setting, see “Changing the default settings” on page 6-10.
Note:
Most software controls the character table and auto line feed. If your
software controls these features, you may never need to set them with
the control panel.
About the default settings
Print direction
Your printer has three direction settings: unidirectional (may
appear as
UnD
on control panel), bidirectional (
BD
), and
automatic (
Auo
).
Note:
Most software controls this setting. If your software does, you may
never need to set it with the control panel.
The auto matic setting switches the printer automatically
between bidirectional (for text data) and unidirectional (for
graphics data) printing.
6
R
Loire-p Ref. Guide
Rev.c
A5 size Chapter 6
02-24-97 DR, pass 0
The Control Panel
6-5
To Next Page
Loading...
