Epson Stylus Photo 1390 - 4.2.6.2 CSIC Assy

EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 94
4.2.6.2 CSIC Assy
1. Remove the CR Scale. See Section 4.2.6.1 on page 92.
2. Open the Cartridge Cover and remove all Ink Cartridges.
3. Disengage the two tabs of the Head FFC Cover, and while disengaging the dowel
with a flathead screw driver, slide it upward, and rotate it around the Hinge by 90°.
Figure 4-48. Removing the Head FFC Cover
4. Using the special tool (refer to p75), disengage tab A of the CSIC Assy on the right
rear side of the Carriage Unit.
Figure 4-49. Removing the CSIC Assy (1)
 Pass the CR Scale through the slit of the CR Encoder.
Figure 4-45. Installing the CR Scale (1)
 Set the CR Scale so that the chipped edge come to the top left
corner.
Figure 4-46. Installing the CR Scale (2)
 Place the right end of the CR Scale correctly so that it is not
hooked onto the hooked portion of the Right CR Shaft
Mounting Plate.
Figure 4-47. Installing the CR Scale (3)
CR Encoder
CR Scale
CR Scale
Chipped edge
OK
NG
CR Scale
Hooked Portion
C A U T I O N
 When removing the Head FFC Guide, do not use tools with
sharp ends as the FFC may get damaged.
 Be careful not to break the Tabs of the FFC Guide.
Head FFC Cover Hinge
Tab
Dowel
Ink Cartridge Cover Head FFC Cover
Tab A
Carriage Unit
Tab A