Epson Stylus Photo 1390 - 4.2.6.3 Printhead

EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 95
5. Using the special tool (refer to p75), disengage tab B of the CSIC Assy on the right
rear side of the Carriage Unit.
Figure 4-50. Removing the CSIC Assy (2)
6. Lift up the CSIC Assy from the Carriage Unit to disconnect the CSIC FFC, and
remove the CSIC Assy.
Figure 4-51. Removing the CSIC Assy (3)
4.2.6.3 Printhead
1. Remove the CSIC Assy. See Section 4.2.6.2 on page 94.
2. Remove the three C.B.P. 2.6x8 screws that secure the Printhead using Phillips
Screw Driver, No.1, and remove the Printhead by lifting it up vertically.
Figure 4-52. Removing the Printhead (1)
3. Disconnect the two Head FFCs on the back side, and remove the Printhead.
Figure 4-53. Removing the Printhead (2)
Tab B
Carriage Unit
Tab B
Removal Direction
CSIC Assy
CSIC FFC
Rear side of CSIC Assy
Connector
Hook
7) C.B.P. 2.6x8
(3±0.5 kgf.cm)
1
2
3
Head FFC