Epson Stylus Photo 1390 - Page 97

EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 97
 When installing the APG Assy, make sure that the FLAG
Release Assy is NOT in a released state (with the Upper Paper
Guide down).
Figure 4-56. Installing the APG Assy
 Refer to Figure 4-54, and route the APG Connector Cables
correctly.
FLAG Release Assy
Released
Not Released
Upper Paper Guide
 Match the phase of the APG Assy following the next steps.
1. Match the delta marks of Spur Gear 16 and Combination
Gear 22, 28.8, 32.4.
2. At the position where the tab can be identified through the
cutout of the PG Frame, match the delta marks of Spur
Gear 16 and PG Cam (Left).
Figure 4-57. Phase Matching
 Tighten the screws in the order shown in Figure 4-55.
Delta Marks
Spur Gear 16
Combination Gear
22, 28.8, 32.4
Delta Marks
Tab
Spur Gear 16 PG Cam (Left)