Epson Stylus Photo 895 - Page 80

EPSON Stylus PHOTO 895/785EPX Revision A
Disassembly and Assembly Disassembly 80
Figure 4-14. Removing the two screws tightening the Printhead
7. Remove the Printhead from the CR unit
C.B.P-TITE 3x8 F/ZN
B-TITE SEMSW2 2.5x5 F/ZB
C H E C K
P O I N T

Place the Printhead’s FFC in the cable holder by the four
portions indicated in the following Figure 4-15. "Placing
the Printhead’s FFC".
 Make sure that the Head Grounding Plate is installed to
the carriage correctly. Refer to Figure 4-16. "Printhead
installing the position pin & the grounding plate".
 Make sure that two holes of the Printhead correctly fit in
the installing position pins. Figure 4-16. "Printhead
installing the position pin & the grounding plate".
 Installation of I/C must be carried out by I/C replacement
sequence. Otherwise, ink may not eject properly.