EPSON Stylus PHOTO 895/785EPX Revision A
Disassembly and Assembly Disassembly 81
Figure 4-15. Placing the Printhead’s FFC
Figure 4-16. Printhead installing the position pin & the grounding plate
Tightening Torque for screw
• C.B.P-TITE 3x8 F/ZN screw for printhead: 6 +/- 1 kgf.cm
• B-TITE SEMSW2 2.5x5, F/ZB screw for printhead: 2 +/- 0.5 kgf.cm
A D J U S T M E N T
R E Q U I R E D
When the Printhead is replaced with a new one, following
adjustments must be performed in the order below:
1. Initial ink charge
2. Printhead ID input
3. Bi-d adjustment
When the Printhead is removed and reinstalled, only the following
adjustment is required.
1. Head cleaning
2. Bi-d adjustment
Head installing position pins
Head grounding plate
To Next Page
Loading...
