EPSON Stylus PHOTO 895/785EPX Revision A
Disassembly and Assembly Disassembly 94
4. Remove four screws (C.B.S 3x6 F/ZN) securing the Ink system frame and the Cap
assembly to the frame.
Figure 4-41. Removing four screws securing the Ink system
5. Remove the Ink system unit (Cap and Pump unit) carefully along with the Ink
system frame.
6. Release one hook for Cap assembly on the Ink system frame and take the Cap
assembly out from the Ink system frame.
7. Disconnect the waste drain ink tube carefully from the bottom of the Cap assembly
Tightening torque for screw
•
C.B.S (P4) 3x6 F/ZN
screw for pump unit cover
: 9 +/- 1 kgf.cm
• C.B.S 3x6, F/ZN screw for ink system frame and cap assembly: 9 +/- 1 kgf.cm
C A U T I O N
When the Ink system unit is removed, be careful that the gears do
not come off from each shaft on the Ink system frame.
C.B.S 3x6 F/ZN
To Next Page
Loading...
