Epson Stylus Photo 895 - Page 95

EPSON Stylus PHOTO 895/785EPX Revision A
Disassembly and Assembly Disassembly 95
C A U T I O N
 Since the compression spring is included in the Pump assembly,
watch out for the spring and the gear that pop out from the unit
when the Pump assembly is removed from the Ink system unit.
 When replacing the cleaner head built in the Pump assembly, be
careful of the following points.
1) Do not touch the cleaner head with your bare hands. Ware
gloves or use tweezers.
2) Do not smear the head cleaner with oil or grease.
 When installing the Cleaner head, set the rubber side (black
side) facing toward the right side of the frame.
 When installing the Cleaner head, set the two square cut offs on
the Cleaner head into the two hooks on the Ink system.
Figure 4-42. Cleaner Head Assembly
Cleaner head
Hook & cut off
C A U T I O N
 When replacing the Cap Assembly, do not touch the sealing
rubber portion of the Cap Assembly.
 The component parts in the Pump Assembly are not individually
supplied as ASP. So please replace the whole Pump Assembly
when replacing the Pump Assembly.
 Be careful not to crush or leave any stress on the ink tube
connecting the pump assembly and the cap assembly.