EasyManua.ls Logo

Epson Stylus Photo RX585 - 2.1 Overview; 2.1.1 Mechanical Components

Epson Stylus Photo RX585
131 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EPSON Stylus Photo RX585/RX595/RX610 Revision B
Operating Principles Overview 34
2.1 Overview
This Chapter describes the operating principles of the mechanism and electric circuits
of Stylus PHOTO RX585/595/610.
2.1.1 Mechanical Components
The printer mechanism of Stylus PHOTO RX585/595/610 consist of the following
major mechanisms:
The units and circuit boards constituting Stylus PHOTO RX585/595/610 are as
follows:
Figure 2-1. Schematic Printer Mechanism
Table 2-1. Mechanical Components 1
Mechanism Function/Description
CR Assy
Moves on the CR Guide Shaft right and left and performs printing on paper.
The Carriage Assy incorporates the Printhead, PW Sensor, and CR Encoder.
The drive source is the CR Motor.
APG Assy
Controls the platen gap in four stages.
Detects the current height of the carriage with the APG Sensor, and moves
the carriage up and down, driven by the PF Motor.
PF Assy Driven by the PF Motor to turn the PF Roller Shaft for feeding paper.
ASF Assy Driven by the PF Motor to load paper into the Printer Mechanism.
Eject Assy
Driven by the PF Motor to eject the paper (CD-R Tray).
As the Stacker is moved up and down (by manual operation), the paper eject
frame moves up and down so that its height can be adjusted to the media.
I/S Assy
Located in the right end of the mechanism, performs capping the Printhead,
while it is not used, and sucking waste ink. The waste ink is sent to the Waste
Ink Tray via the Waste Ink Tube.
Table 2-2. Mechanical Components 2
Unit / Circuit Board Function/Description
Main Board
Located on the Middle Housing, incorporating the USB I/F (x2), card
reader.
Power Supply Board
Located on the Lower Housing. The power cable can be plugged in and
unplugged.
Panel Board Consists of two pieces located on the Middle Housing.
Scanner Unit CIS consisting of 1200 dpi CCD for reflection (light source: LED)
PF Motor
ASF Assy
CR Motor
LD Roller
CR Encoder
PE Sensor
PF Roller Shaft
APG Sensor
PF Encoder
APG Assy
I/S Assy
CR Lock Lever
Cap Assy
CR Guide Shaft
Eject Roller Shaft
CR Lock Lever
Printhead
CR Assy
PW Sensor
Case Open
Sensor
CD-R Guide
Sensor
CD-R Tray
Sensor

Table of Contents

Related product manuals