Epson Stylus Photo RX585 - 4.5.7 Eject Frame Assy

EPSON Stylus Photo RX585/RX595/RX610 Revision B
Disassembly and Assembly Disassembly and Assembly of Major Parts of Printer 91
4.5.7 Eject Frame Assy
1. Remove the Printer Mechanism (p.76)
2. Remove the Head FFC from the Front Frame. (Fig. 4-76)
3. Release the cable of the CD-R sensor from the hook of the Eject Frame.
(Fig. 4-77)
4. Remove the screw securing the Cable Holder Frame.
5. Remove the right and left screws (x2) securing the Front Frame, and remove the
Front Frame from the printer body.
6. Remove the Eject Frame Assy from the printer body. (Fig. 4-78)
Figure 4-76. Removing the Head FFC
Figure 4-77. Removing the Front Frame
Figure 4-78. Removing the Eject Frame Assy
 Before installing the Eject Frame, install the Left EJ Frame
Spring (longer), and the Right EJ Frame Spring (shorter)
temporarily, in the respective positions shown below on the
Eject Frame. After installing the Front Frame, move the Right
EJ Frame Spring to the spring support.

Fit the shaft holders (left and right) on the underside of the Eject
Frame onto the Paper Eject Roller Shaft.
(Fig. 4-78)

After installing the Front Frame, confirm the engagement of the
protrusions (x2), and then tighten the screws in the specified order.
(Fig. 4-77)
 Lubrication is necessary. Refer to the following section and
lubricate the specified points:
LUBRICATION OF APG UNIT (p.119)

After installing the Cable Holder Frame, confirm the engagement
of the protrusion, and then tighten the screw.
(Fig. 4-77)

After installing the Head FFC as shown, move the carriage several
times and confirm that the FFC is free from undue tension or
excessive allowance.
(Fig. 4-76)
Right EJ Frame Spring
Left EJ Frame Spring
~Left side~ ~Right side~
~Temporarily~
Head FFC
Front Frame
Locate it on the folded part
1±1 mm
Acetate Tape (18x50mm)
Acetate Tape (30x40mm)
2
1
Protrusion
C.B.S-TITE 3x6
Torque : 0.8±0.1N
·m
C.B.S-TITE 3x6 (x2)
Torque : 0.8±0.1N
·m
Protrusion
Protrusion
Release the harness
Cable Holder Frame
Front Frame
Eject Frame Assy
Shaft holder
Shaft holder