Epson Stylus Photo RX585 - Page 86

EPSON Stylus Photo RX585/RX595/RX610 Revision B
Disassembly and Assembly Disassembly and Assembly of Major Parts of Printer 86
 Lubrication is necessary. Refer to the following section and
lubricate the specified points:
LUBRICATION OF ASF ASSY (p.121)
LUBRICATION OF LD ROLLER SHAFT (p.120)
 When installing the ASF Assy, make sure that the composite
gear, the chip of Change Lever and the hooks (x2) are engaged
properly.

Tighten the screws in the specified order. (Fig. 4-64)
 Install the LD Roller aligning the arrow on the LD Roller with
the arrow on the blade of the shaft. Make sure the LD Roller is
securely attached without any gap or misalignment.
ASF Unit
Align the arrows
Blade
LD Roller Shaft
LD Roller
LD Roller Shaft