Epson Stylus Photo RX585 - Page 94

EPSON Stylus Photo RX585/RX595/RX610 Revision B
Disassembly and Assembly Disassembly and Assembly of Major Parts of Printer 94
 Lubrication is necessary. Refer to the following section and
lubricate the specified points:
LUBRICATION OF PAPER GUIDE FRONT ASSY (p.117)
 Lead the cable of the CD-R Sensor as shown below.
 See Fig. 4-83 and install the Ground Spring.
 Make sure the four tips of the Front Paper Guide Pad are
placed on the Waste Ink Pad.
~Printer front bottom left~
Lead the cable here
[Bottom Side]
Tip of Front Paper
Guide Pad
Waste Ink Pad Position
Tip
Tip
[Bottom Side]