The Control Panel 169
THICKNESS PAT
You can print the paper thickness detection pattern. If you select
STANDARD in PAPER NUMBER, the pattern is not printed.
THICKNESS NUM
If you use Epson special media, normally select AUTO. If you use
non-Epson special media, check the paper thickness detection
pattern, and then enter the number for the print pattern with the
smallest gap.
CUT METHOD
You can specify a cutting method: STANDARD, THIN PAPER, THICK,
FAST, or THICK, SLOW.
PPR FEED ADJ
You can set the paper feed amount. The range is -0.70 to 0.70%.
EJECT ROLLER
You can select AUTO, SHEET, ROLL CURLED, or ROLL NORMAL.
AUTO The printer selects the most appropriate setting
automatically. When you use Epson special media,
usually select this setting.
SHEET If you want to print on cut-sheet paper that is non-Epson
special media, select this setting.
ROLL CURLED If you want to print on strongly curled roll paper that is
non-Epson special media, select this setting.
Note:
Make sure that the ink is dry enough on the paper
before the roller touches the media; otherwise, the ink
will soil the roller surface, which stamps on the prints.
ROLL NORMAL If you want to print on roll paper that is non-Epson
special media, select this setting. When roll paper is
selected for the printer, this parameter is selected and
no feed roller is used. If you select this parameter while
using cut sheets, you need to eject the cut-sheet paper
one by one.
To Next Page
Loading...
