The Control Panel 188
Maintenance Mode
Maintenance mode setting procedure
This section describes how to enter Maintenance mode and how
to make settings with the buttons on the control panel.
To make the Maintenance mode settings, follow the steps below.
Note:
Press the Paper Source button to return to the previous step.
1. Enter Maintenance mode
Confirm the printer is turned off first. While pressing and
holding the Pause
button, press the Power button to
turn on the printer.
2. Select an item
Press the Paper Feed or Paper Feed button to select a
desired item.
3. Set the item
Press the Menu
button to enter the selected item. The first
parameter is displayed on the LCD panel.
4. Select a parameter
Press the Paper Feed or Paper Feed button to select a
parameter for the item.
5. Set the parameter
Press the Menu
button to store the selected parameter.
If the parameter is for execution only, press the Menu
button to execute the function for the item.
Note:
If second parameter is displayed on the LCD panel, repeat the steps
4 and 5 to select and set the second parameter.
To Next Page
Loading...
