Paper Handling 224
Loading paper into the rear manual feed slot
Note:
❏ You can load one sheet at a time into the rear feed slot.
❏ Load paper with the printable surface up.
❏ Paper with a thickness between 0.08 and 0.79 mm can be set in the
landscape position. However, always set recycled or plain paper and
A4, Letter size, or 8 × 10 in. paper in the portrait position,
regardless of the thickness.
1. Make sure the printer is on and in the READY state.
2. Press the Paper Source button to select Sheet .
3. Hold the left and right edges of the paper. Align the left edge
of the paper with the target paper size on the roll paper cover,
and then insert the paper until it meets resistance.
The printer automatically feeds the paper to the printing
position.
Note:
If you press the Pause
button, the printer starts to feed the paper
to the printing position immediately.
To Next Page
Loading...
