The Control Panel 187
Setting the alert value of the paper
You can get a message when there is not much left, by setting the
alert value using the steps below.
Note:
This setting is available only when you select Roll Paper or Cut Sheet
for PAPER COUNTER in Maintenance mode.
1. Press the Menu
button to enter Menu mode.
2. Press the Paper Feed or Paper Feed button to display
PRINTER SETUP, and then press the Menu
button.
3. Press the Paper Feed or Paper Feed button to display
ROLL COUNTERor SHEET COUNTER, and then press the Menu
button.
4. Press the Paper Feed or Paper Feed button to select
the length of the roll paper (between 5 and 99.5 m or 15 and
300 ft) or the number of cut-sheet paper (between 10 and 250)
set in the printer, and then press the Menu
button.
5. The screen changes so that you can select the alert value. Press
the Paper Feed or Paper Feed button to select the alert
value. For roll paper, select a value between 1 and 15 m or 3
and 50 ft. For cut-sheet paper, select a value between 5 and 50.
6. Press the Menu
button to set the alert value.
7. After you set the alert value, press the Pause button to
return to the READY status.
To Next Page
Loading...
