Epson Stylus Pro 4880 - Page 98

Variety of Printings 98
Note:
When you want to cut prints manually, select OFF.
Explanation Normal Cut is default
setting.
The top area may
smear because the
top area of the roll
paper is cut while the
print operation is
stopped.
If the cut position is
slightly shifted, the
image on the
continuous page
remains on the top or
bottom area;
however, the
printing time gets
shorter.
If you select Single
Cut and print only a
piece of paper, the
operation will be the
same as Double Cut.
If you print more than
one paper
continuously, cut
1 mm along the
inside of each
picture to avoid
creating a margin
between pictures.
The top area may
smear because the
top area of the roll
paper is cut while the
print operation is
stopped.
Because inside of
each picture is cut in
order to not leave a
white area in the top
and bottom position,
the size of the paper
gets 2 mm shorter.
After cutting the
bottom area of the
previous page, the
printer feeds the
paper and then cuts
the top area of the
next page. Because
of that, 80 to 130 mm
of scrap of paper is
produced. Take
care to cut the
paper precisely.