Epson Stylus Pro 7400 - Page 235

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 235
4.2.4.3 INLETS ASSY.
1. Remove the Rear Cover. See Section 4.2.3.6 on page 225.
2. Remove the screw that secures the grounding wire.
 One C.C.S. M4 x 8 screw
3. Disconnect the connector of the INLET ASSY. from the P/S BOARD ASSY., and
release the INLET ASSY harness and the grounding wire from the retaining clip.
4. Remove the screw that secures the INLET ASSY.
 One C.C.S. M4 x 8 screw
5. Slide the INLET ASSY leftwards to release its right bottom tab from the notch,
and remove the INLET ASSY.
Figure 4-42. Removing the INLET ASSY.
W A R N I N G
When removing the INLET ASSY., do not start the work
immediately after disconnecting the AC cable. Wait for at least five
minutes for the electrolytic capacitor to finish discharging residual
charges.
INLET ASSY.
P/S BOARD ASSY.
Retaining Clip
Connector
2: C.C.S. 4x8
4: C.C.S. 4x8
Grounding
Wire
Tab
5