Epson Stylus Pro 7400 - Page 242

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 242
7. Tilt the MAIN TUBE HOLDER frontward and pull out the CR BELT from the
retainer of the CARRIAGE ASSY.
Figure 4-57. Removing the CR BELT (3)
A D J U S T M E N T
R E Q U I R E D
Whenever the CR BELT is reinstalled or replaced, the
corresponding adjustment must be carried out. See Chapter 5 on
page 292.
Retainer