Epson Stylus Pro 7400 - Page 241

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 241
5. Remove the CR DRIVE PULLEY ASSY. and the CR BELT from the two notches
of the Driven Pulley Tension Plate, and remove the CR BELT from the CR
DRIVE PULLEY ASSY. See Figure 4-55.
6. Remove the two screws that secure the MAIN TUBE HOLDER. See Figure 4-56.
 Two C.P.S.(S-P2) M3 x 8 screws
Figure 4-55. Removing the CR BELT (2)
Figure 4-56. Screws for the MAIN TUBE HOLDER
C A U T I O N
When performing the next step, be careful not to lose the Bearing
Retainer and the Driven Pulley Shaft as they may come off the CR
DRIVE PULLEY ASSY. If they come off, reattach them with
reference to the figure below.
Figure 4-54. Reassembling the CR DRIVE PULLEY ASSY.
Set the two positioning holes of the MAIN TUBE HOLDER onto
the two guide pins. See Figure 4-56.
Bearing Retainer
Driven Pulley Shaft
CR DRIVE PULLEY ASSY.
Notches
C.P.S.(S-P2) 3x8
Guide Pins
MAIN TUBE HOLDER
TUBE, SUPPLY, INK