Epson Stylus Pro 7400 - Page 269

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 269
9. Slide the HOLDER, HEAD downward and then pull it toward you releasing the
two lower tabs and one upper tab and pulling out the two rails. And remove the
HOLDER, HEAD while being careful not to let the HEAD FG PLATE; C contact
with the frame.
Figure 4-107. Removing the HOLDER, HEAD
C A U T I O N
When removing the PRINT HEAD, be careful not to touch and
damage the nozzles and Ink Supply Needles.
 Insert the two rails of the HOLDER, HEAD under the two ball
bearings.
 Make sure the positioning tab is set in the upper left groove of
the HOLDER, HEAD.
Figure 4-106. Reinstalling the HOLDER, HEAD
Rails
Ball Bearings
Positioning Tab
Groove
Lower Tabs
Rails
Upper
Tab
9-1
HOLDER, HEAD
9-1
9-2