Epson Stylus Pro 7400 - Page 279

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 279
HOLDER ASSY., IC, LEFT
1. Remove the L SIDE COVER ASSY. See Section 4.2.3.5 on page 224.
2. Release the four TUBE, SUPPLY, INK from the four retaining tabs and the
retaining clip.
3. Release the four FFCs from the three hooked tabs and disconnect them from the
CSIC RELAY BOARD.
4. Lower the I/C, LOCK LEVER.
5. Remove the piece of the acetate tape that secures the harness of the I/C LEVER
SENSOR L.
6. Release the two tabs that secure the I/C LEVER SENSOR L and remove it.
7. Remove the connector from the I/C LEVER SENSOR L.
Figure 4-126. Releasing the TUBE, SUPPLY, INK and Removing the I/C LEVER
SENSOR L
2: Retaining tabs Retaining clip
I/C, LOCK LEVER
4
Acetate tape
I/C LEVER SENSOR L
Connector
6: Tabs
TUBE, SUPPLY, INK
Connector
FFC
3: Hooked tabs
HOLDER ASSY.,
IC, LEFT