Epson Stylus Pro 7400 - Page 282

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 282
11. Release the hooked tab that secures the HOLDER ASSY., IC, LEFT, and remove
it.
Figure 4-132. Removing the HOLDER ASSY., IC, LEFT (1)
C A U T I O N
When performing the next step, be careful not to pull the HOLDER
ASSY., IC, LEFT too much as it is still connected to the printer
with the TUBE, SUPPLY INK.
C A U T I O N
When reinstalling the HOLDER ASSY., IC LEFT, be careful not to
trap the Front Sensor harness and the TUBE, INK, WASTE; L
between the two screwed tabs and the frame.
Figure 4-130. Screwed Tabs located at Upper Side of the HOLDER
ASSY., IC, LEFT
Screwed tabs
Front Sensor
Harness
TUBE, INK, WASTE; L
Make sure to insert the two tabs of the HOLDER ASSY., IC, LEFT
into the two slots.
Figure 4-131. Reinstalling the HOLDER ASSY., IC, LEFT
Tabs
Hooked tab
11-1
11-2