Epson Stylus Pro 7400 - Page 289

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 289
C A U T I O N
The COVER, MIST may come off the frame after removing the
BOX ASSY., FLUSHING (R). If the COVER, MIST come off,
reattach them on the frame matching up their holes with the three
tabs and one guide pin as shown in the figure below.
Figure 4-143. Reattaching the COVER, MIST
COVER, MIST
Guide Pin
Tabs
Set the two guide pins of the BOX ASSY., FLUSHING (R) in the
positioning holes on the frame.
Figure 4-144. Reinstalling the BOX ASSY., FLUSHING (R)
A D J U S T M E N T
R E Q U I R E D
Whenever the BOX ASSY., FLUSHING (R) is replaced, the
corresponding adjustment must be carried out. See Chapter 5 on
page 292.
Guide Pins