Epson Stylus Pro 7400 - Page 290

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 290
BOX ASSY., FLUSHING (L)
1. Remove the L SIDE COVER ASSY. See Section 4.2.3.5 on page 224.
2. Remove the 2 screws that secure the BOX ASSY., FLUSHING (L).
 Two C.C.P. M3 x 8 screws
3. Pull out the TUBE, INK, WASTE; L from the Ink Exhaust through the two holes
of the frame, and remove the BOX ASSY., FLUSHING (L).
Figure 4-145. Removing the BOX ASSY., FLUSHING (L)
C A U T I O N
When reinstalling the TUBE, INK, WASTE; L, make sure to insert
it correctly into the waste ink outlet and route the tubes as shown in
the figure right, or ink may leak.
 Set the two positioning holes of the BOX ASSY., FLUSHING
(L) onto the guide pins on the frame.
 Before screwing the BOX ASSY., FLUSHING (L), make sure
that its upper edge is not in contact with the ROLLER, PF.
A D J U S T M E N T
R E Q U I R E D
Whenever the BOX ASSY., FLUSHING (L) is replaced, the
corresponding adjustment must be carried out. See Chapter 5 on
page 292.
BOX ASSY.,
FLUSHING (L)
Left Front of the Printer
TUBE, INK, WASTE; L
Ink Exhaust
Guide Pins
Holes
C.C.P 3x8
ROLLER, PF