Epson Stylus Pro 7400 - Page 343

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Adjustment Basic Adjustment 343
ADJUSTMENT PROCEDURE (ENTIRE PROCESS WORKFLOW)
1. Turn the printer power on.
2. Start the adjustment program, and select [Colorimetric Calibration Tool].
3. Click [Run] to start the “Colorimetric Calibration Tool”.
4. Click the [Perform entire process] button.
5. Make sure that the “READY” message is displayed on the printer LCD, and click
[Next].
6. Select the connected printer from the printer list, and check if the LCD panel backlight
of the printer flashes by clicking [Confirming flashing of the backlight].
7. Click [Next], then the message that prompt you to agitate the ink inside the cartridges
will be displayed.
8. Click [OK] to start the cleaning.
Figure 5-65. Colorimetric Calibration ID Startup Screen
C H E C K
P O I N T
If the printer has not been used for more than two weeks, it is
recommended to agitate the ink inside the cartridges to get an
accurate result. Remove all the ink cartridges from the printer, and
shake them gently for four or five times.