Epson Stylus Pro 7400 - Page 66

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Product Description Control Panel 66
If the width of image is larger than that of the specified printable area, the extended
width of the image is clipped off from its right side. In such case, a vertical page line is
not printed.
Figure 1-11. Roll Paper Margin (2)
Note "*": Top margin of roll paper can be set with “Set the paper top margin” (SN command).
When the printer receives the command, it determines the top margin as follows:
• When the “Roll Paper Margin” is set to other than Default
The printer creates a top margin according to the panel setting.
• When the “Roll Paper Margin” is set to Default
The printer creates a top margin according to the SN command.
If a top margin information is not included in the SN commands, the printer adopts
the default top margin setting.
Note 1: Using the Borderless Print function, left and right margins can be set to 0.
2: When the following patterns are printed, left and right margins are fixed to 3mm.
Roll Paper Width X
Printable Area
X *
X
X
X
Clipped Area
Cut Position or Border
Adjustment Patterns Menu Command
Nozzle Check Pattern Test Printing Menu NC Command
Auto Nozzle Check Pattern
↑ ↑
Status Print
↑
SS Command
Job Information Print
↑ ↑
User Paper Print
↑↑
Paper Thickness Detection Pattern User Paper Setting Menu
↑
Cutter Position Adjustment PRINTER SETUP
↑
Auto Nozzle Check for each job
↑ ↑
Manual Uni-D GAP Adjustment Menu DT/DC Command
Manual Bi-D K
↑ ↑
Manual Bi-D
↑↑
F/W ROM Version Print --- VI Command