139
LCD screen message Solution
Warming Up...
Force to start printing
One or more heaters is warming up to the specified temperature. To
start printing without waiting for the heater to warm up, press the OK
button.
Command Error
Check print settings on RIP.
Press the pause/cancel button and select Job Cancel. Make
sure the installed RIP software is compatible with the product.
Clogged nozzles detected.
Cleaning recommended.
Perform head cleaning if necessary.
F/W Install Error
Firmware update failed.
Restart the printer.
Turn off the product, wait a few minutes, and turn it on again. Then
reinstall the firmware again.
If this message persists, contact Epson for support.
Print head is nearing end of
service life.
The print head is nearing the end of its service life. Contact Epson
for support.
Auto Take-up Reel Unit stopped.
Press the pause/cancel button and select Job Cancel to cancel
printing. Then set the Auto switch on the auto take-up reel to the off
position, set it back to the original position, and reattach the media to
the auto take-up reel.
Media Size Error
Load correct size media.
Raise the media loading lever and remove the currently loaded
media. Be sure the media is at least 11.8 inches (300 mm) wide.
If this message appears even when the media is the correct width,
turn off the Media Size Check setting and try printing again.
To Next Page
Loading...
