G Auto switch
Use this switch to select the auto take-up direction.Off Choose Off to disable auto take-up.
H Manual switch
Use this switch to select the manual take-up direction.Auto The selected option takes effect when the Auto switch is
in the Off position.
I Casters
There are two casters on each leg. Once installation is complete, the front casters should be kept locked while the
printer is in use.
J Airflow vents
These vents vent air from inside the printer. Do not obstruct these vents.
K Waste ink bottle holder
Place the waste ink bottle in this holder.
L Adjuster
The adjusters keep the printer in place. After installing the printer, keep it securely in place during use.
M Waste ink bottle
Waste ink collects in this bottle.
Replace with a new waste ink bottle when the level approaches the line.
N Waste ink tube
Waste ink is discharged from this tube. Be sure the end of this tube is in the waste ink bottle while the printer is in
use.
O Ink cartridges
Install all ink cartridges into each slot.
P Lock levers
Raise the levers to unlock the ink cartridges prior to removal. Lower the levers to lock the cartridges in place after
insertion.
Q Cartridge check lamp
This lamp lights when an ink cartridge error occurs.
On : An error occurred. Check the contents of the error on the control panel's screen.
Off : No error.
R AC inlet #1/AC inlet #2
Connects the power cable. Be sure to connect both cables.
S LAN port
U “LAN port” on page 17
T USB port
Connects the USB cable.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Introduction
11
To Next Page
Loading...
