F
Loosen the right roll core holder fixing screw and
remove the roll core holder from the roll.
G
Lower the roll onto the roll support.
Using the Optional Heavy Roll Auto
Take-up Reel Unit
This section explains how to remove media from the
take-up reel using a lifter.
The following types of lifter can be used.
❏ Fork or platform thickness: 28 mm or less
❏ Fork or platform can be lowered to approx.190mm
from the floor.
!
Caution:
❏ Because the media is heavy, it should not be
carried by one person. When loading or
removing the media, use at least two persons.
Using a lifter is recommended when handling
a media that is 40 kg or heavier.
❏ Follow the instructions in the manual when
loading media or roll cores or removing media
from the take-up roll.
Dropping media, roll cores, or take-up rolls
could result in injury.
A
Cut the media and roll the cut end onto the
take-up reel.
U “Cutting Media” on page 54
B
Insert the lifter between the media and the auto
take-up reel unit and adjust the height to support
the take-up roll.
C
Loosen the left roll core holder fixing screw and
remove the roll core holder from the roll.
D
Loosen the right roll core holder fixing screw and
remove the roll core holder from the roll.
Before Printing
To maintain print quality, perform the following
inspection before starting work each day.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Basic Operations
60
To Next Page
Loading...
