E
Lower the tensioner.
F
Press the d button to feed the media until the
take up roll core begins to turn.
c
Important:
The auto take-up reel unit will not function if
the tensioner is raised.
Removing the Take-up Roll
The procedure for removing media varies depending on
whether you are using the installed auto take-up reel
unit or the optional auto take-up reel unit for heavy
media.
Follow the steps below when using the supplied auto
take-up reel unit.
When the Heavy Roll Auto Take-up Reel Unit is
installed U “Using the Optional Heavy Roll Auto
Take-up Reel Unit” on page 60
When the Standard Auto Take-up
Reel Unit Is Installed
This section describes how to remove media from the
take-up reel.
!
Caution:
❏ Because the media is heavy, it should not be
carried by one person. When loading or
removing the media, use at least two persons.
❏ Follow the instructions in the manual when
loading media or roll cores or removing media
from the take-up roll.
Dropping media, roll cores, or take-up rolls
could result in injury.
A
Cut the media and roll the cut end onto the
take-up reel.
U “Cutting Media” on page 54
B
To prevent the media from sliding off the roll,
support the roll at its left end.
C
Loosen the left roll core holder fixing screw and
remove the roll core holder from the roll.
D
Lower the roll onto the roll support.
E
To prevent the media from sliding off the roll,
support the roll at its right end.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Basic Operations
59
To Next Page
Loading...
