C
Remove the media holding plates.
D
Cut the media with the cutter.
Pass the blade of the cutter down the cutting
groove.
Note:
❏ If you are using the auto take-up reel unit, set the
Auto switch on the auto take-up reel unit to Off
before using the Manual switch to position the
media over the cutting groove.
❏ If you are using the SC-S70600 series or SC-S50600
series and do not intend to make additional prints,
raise the media loading lever to prevent
deformation of the pressure rollers.
Removing Media
You can now remove the media from the roll holders. To
remove the media, reverse the steps you followed to load
it.
Using the Auto Take-up
Reel Unit
Media Loading and Take Up
The auto take-up reel unit automatically takes up media
as it is printed, improving the efficiency of unmanned
operation.
The auto take-up reel unit for this printer can take up
media in either of the following directions.
Counterclockwise Clockwise
Counterclockwise take up places the printed surface on
the outside of the roll.
Clockwise take up places the printed surface on the
inside of the roll.
The explanation that follows uses the supplied auto
take-up reel unit for illustrative purposes, but the same
procedure can be followed when using the optional auto
take-up reel unit for heavy media.
!
Caution:
❏ Be sure that your hands or hair do not get
caught in the auto take-up reel unit while it is
in operation.
Failure to observe this precaution could result
in injury.
❏ Follow the instructions in the manual when
loading media or roll cores or removing media
from the take-up roll.
Dropping media, roll cores, or take-up rolls
could result in injury.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Basic Operations
55
To Next Page
Loading...
