Pressing this button displays the Heating & Drying
menu, where you can adjust the Heater
Temperature. If the additional print drying system
(supplied with the SC-S50600 series; optional with
other models) is attached, you can also adjust
Additional Dryer settings. These options can be
adjusted during printing.
U “The Media Setup Menu” on page 100
K
# button (maintenance button)
Pressing this button displays the Maintenance
menu, which contains such items as Nozzle Check,
Cleaning, Head Washing, Head Maintenance, and
Waste Ink Counter. This button is disabled during
printing.
U “The Maintenance Menu” on page 106
L
W button (pause/cancel button)
❏ The printer enters pause status if this is pressed while
printing. To release the pause status, press the W
button again, or select Pause Cancel on the screen
and then press the Z button. To cancel print jobs
being processed, select Job Cancel on the screen and
then press the Z button.
❏ Pressing this button when menus are displayed closes
the menus and returns the printer to ready status.
M
button (media feed button)
❏ When the printer is in the ready state, you can feed the
media to the cut position by pressing this button and
then Z.
U “Cutting Media” on page 54
❏ When printing is in progress, you can use this button
to adjust media feed.
U “Feed Adjustment (Manual Feed Adjustment)” on
page 67
Understanding the Display
The illustration shows the display for the SC-S50600
series.
A Messages
Displays the printer's status, operation, and error
messages.
U “When a Message is Displayed” on page 111
B Heater temperature
From left to right, this display shows the temperature
settings for the pre-heater, platen heater, and after
heater. The thermometer icons give a rough indica-
tion of the current temperatures of the heaters.
: The heater has reached the selected
temperature.
: The heater has not reached the selected
temperature.
C Media info
❏ From left to right, this display shows the selected
media, platen gap, media width, and media
remaining.
❏ If a media setting bank number created with this
printer is selected as the print media, the number
(from 1 to 30) will be displayed. When RIP Settings is
selected, 0 will be displayed.
❏ The selected platen gap is shown as follows.
:1.5
:2.0
:2.5
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Introduction
20
To Next Page
Loading...
