Front section (SC-S30600 series)
A Maintenance cover (left)
Open this cover to clean the area around the print head. Normally closed when using the printer.
U “Cleaning Around the Print Head” on page 81
B After heater
The heater can be used to rapidly dry ink after printing.
U “Heating & Drying” on page 64
C Roll support
Rest media temporarily on these supports when removing the take-up roll. There are two lift levers: one on the left
and one on the right.
U “Media Loading and Take Up” on page 55
D Tensioner
The tensioner maintains tension to prevent the media sagging as it is taken up.
E Roll core holder locking screw
The locking screws keep the roll core holders in place once they have been attached to the roll core. There are two lift
levers: one on the left and one on the right.
F Roll support
Place the used roll core for media take-up on these holders. There are two supports: one on the left and one on the
right.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Introduction
10
To Next Page
Loading...
