For even, high-quality printing, select Printer
Full Width.
Multi-Strike Printing
Choose the number of times each line is printed.
A
Use the d/u buttons to select Multi-Strike
Printing and press the Z button.
B
Use the d/u buttons to choose a value.
C
Select the desired option and press the Z
button.
D
Press the y button to return to the customize
settings menu.
Roll Type
Choose Printable Side Out or Printable Side In
according to how the media is rolled.
A
Use the d/u buttons to select Roll Type and
press the Z button.
B
Use the d/u buttons to select the desired setting
and press the Z button.
C
Select the desired option and press the Z
button.
Tension Measurement
Periodically is recommended in most circumstances.
Choose Off if slack develops in the media or other
printing problems occur.
A
Use the d/u buttons to select Tension
Measurement and press the Z button.
B
Use the d/u buttons to select the desired setting
and press the Z button.
C
Select the desired option and press the Z
button.
Media Tension
Increase tension if creases appear in the media during
printing. The higher the value, the greater the tension.
If you have previously performed Feed Adjustment, you
will need to perform it again after adjusting Media
Tension.
U “Feed Adjustment” on page 62
A
Use the d/u buttons to select Media Tension
and press the Z button.
B
Use the d/u buttons to choose a value.
C
Select the desired option and press the Z
button.
D
Press the y button to return to the customize
settings menu.
Feed Speed
Choose a slower feed speed if media is creased or torn or
sticks together during printing. The lower the value, the
slower the speed.
A
Use the d/u buttons to select Feed Speed and
press the Z button.
B
Use the d/u buttons to choose a value.
C
Select the desired option and press the Z
button.
D
Press the y button to return to the customize
settings menu.
Exiting the Menus
Press W to exit the menus.
Changing Heater and Fan
Settings
Adjust the temperature of the heaters during printing or
turn the fan for the additional print drying system
(supplied with the SC-S50600 series; optional with other
models) on or off.
The default heater temperatures are as follows.
Pre-heater: 40 ˚C
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Basic Operations
65
To Next Page
Loading...
