Supported Media
The following media can be used with the printer.
Print quality is greatly affected by the type and quality of
media used. Choose a media suited to the task at hand.
For information on use, refer to the documentation
supplied with the media or contact the manufacturer.
We recommend that you print a test run and check the
results before purchasing media in large quantities.
c
Important:
Do not use media that is wrinkled, scuffed, torn, or
dirty.
Standard Roll Media System
Roll core size 2 or 3 inch
Roll outer diameter Up to 300mm
Media width
300
*
to 1626 mm (64 inch)
Media thickness Up to 1 mm
Roll weight Up to 40 kg
* Minimum media width for ink layering is 508 mm.
Ink layering U “High Print Quality” on page 23
Heavy Roll Media System
Roll core size 2 or 3 inch
Roll outer diameter Up to 11.81in
Media width
300
*
to 1626 mm (64 inch)
Media thickness Up to 1 mm
Roll weight Up to 80 kg
* Minimum media width for ink layering is 508 mm.
Ink layering U “High Print Quality” on page 23
Moving and Transporting
the Printer
This section describes how to move and transport the
product.
Moving the Printer
This section assumes that the product is being moved to
another location on the same floor without traversing
stairs, ramps, or lifts. See below for information on
moving the printer between floors or to another
building.
U “Transport” on page 125
!
Caution:
Do not tilt the product more than 10 degrees
forward or back while moving it. Failure to observe
this precaution could result in the printer falling
over, causing accidents.
c
Important:
Do not remove the ink cartridges. Failure to observe
this precaution could cause the print head nozzles to
dry out.
Getting Ready
A
Confirm that the printer is off.
B
Remove the waste ink bottle.
U “Replacing the Waste Ink Bottle” on
page 86
C
Disconnect the power cords and all other cables.
D
Remove media from the media feeding unit and
auto take-up reel unit.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Appendix
124
To Next Page
Loading...
